![]() ![]() Designated trademarks, brand names and brands appearing herein are the property of their respective owners. Products sold by come with ’s 1-year, 2-year, or 3-year warranty and do not come with the original manufacturer’s warranty. ![]() is not an authorized distributor, affiliate, or representative for the brands we carry. I can get these questions answered by Rockwell but I wanted to run this by the forums to see what other companies are doing. Upgrading the firmwares or purchasing a legacy license? What about integrators? Does the legacy license come with a ToolKit? I welcome your feedback. How do I upgrade my 元2E without a legacy license?Īgain, I don't have a current need to upgrade but I just want to know how in case I do in the future. but this version is supposed to be supported by Codemeter. I'm assuming since I don't have a legacy license yet. It is available (and I have it installed) on RSLogix5000 but it will not open for me. Did I miss something? Or did I get bad information?Ģ) I attempt to obtain a Studio 5000 V20.05 and it's not available. I've found several issues with this.ġ) I'm only able to download firmware V20.019 for the 元2E. In the meantime, I'm exploring upgrading the firmware on a spare 1769-元2E/A from v19 to v20.05 as this was our other option versus purchasing the legacy license. I work in a regulated environment and will be forced to purchase the 'Legacy' license to support our validated equipment containing these older versions. At least this is what I was told after I was unable to open one of our v19 projects. I should also note that if installing the version sequentially, v21.00.00 then v21.03.00, the 21.03.00 will overwrite the 21.00.As with most of you with TechConnect contracts, you may have noticed that RSLogix5000/Studio 5000 license upgraded at some point to where it is no longer valid to activate any version 20.04.02 or older. ![]() Given that the site i work at has multiple programmers and engineers it was best to not make changes to the controller version and download the converted program to the PLC, the only way for the program to connect to the controller after converting to 21.03.00.Īnyways, hopefully this saves you some potential headache should you run across this same issue in house or with a client. However the converted program would now not open in version 21.00.00. Tried the conversion of the controller while on the server with 21.03.00 installed, made a copy of the program file and used that for conversion, after the conversion the controller version was still 21.11. Went online with an older server build with 21.00.00 installed and went online just fine. The program was originally built in 21.00.00 and was not opening in 21.03.00. To open this project you must: 1) Cancel and install Logix Desginer support for firmware revision 21.00, or 2) Change the controller's revision and/or type in the project." Giving the fault "Logix Designer support for this revision is not installed. Anyways had just installed v21.03.00 of Studio5000 on a new VM system and was going through testing connectivity on existing programs prior to break down of equipment and ran across an issue with opening some of existing PLC Programs. Ran into this issue and took a while troubleshooting the compatibility, was not in the release notes that i could find. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |